Arduino Pro Micro

৳ 620.00

This tiny little board does all of the neat-o Arduino tricks that you’re familiar with: 4 channels of 10-bit ADC, 5 PWM pins, 12 DIOs as well as hardware serial connections Rx and Tx. Running at 16MHz and 5V, this board will remind you a lot of your other favorite Arduino-compatible boards but this little guy can go just about anywhere. There is a voltage regulator on board so it can accept voltage up to 12VDC.

There is a PTC fuse and diode protection to the power circuit and corrected the RX and TX LED circuit.

SKU: DEV0028 Category: Tags: , , , , , , , ,

Description

Features: 
ATmega32U4 running at 5V/16MHz
Supported under Arduino IDE v1.0.1
Recommend power supply for board: 6-7V, less than 9V
On-Board micro-USB connector for programming
4 x 10-bit ADC pins, 12 x Digital I/Os
Rx and Tx Hardware Serial Connections

How to use?
1. Connected to computer. (If this module cannot be recognized by your computer, please refer to this link to install the driver https://www.arduino.cc/en/Guide/DriverInstallation)
2 Opened Arduino IDE and loaded Blink sketch.
3. Set board to Leonardo and selected the appropriate COM port (It showed up in the list already identified as a Leonardo).
4. Connected an LED to pin 9 and modified the sketch accordingly.
5. Hit upload and within a few seconds having a blinking LED.

Schematics: https://www.dropbox.com/s/dksat7ildg6mb5s/Pro-Micro-v11-5V_B.pdf

Documents and Downloads

  • Arduino Pro Micro Driver
  • Windows Driver Installation Guide
  • Linux / Mac Driver Installation Guide

Reviews

There are no reviews yet.

Be the first to review “Arduino Pro Micro”

Your email address will not be published. Required fields are marked *

You may also like…

Related products